An o-ring boss seal is a technique for joining two fluid-carrying pipes, hoses, or tubing. In an o-ring boss (abbreviated ORB) system, a male-threaded part is inserted into a female-threaded part, providing a mechanical seal. This system differs from others in that an additional nut is tightened over an o-ring into a chamfered area, creating a fluid-tight seal.
As we are concerned that the pressure sensor/transducers are widely used in various industries, hydraulics and pneumatic control systems, Air-conditioning unit and refrigeration equipment, water treatment & water supply system and air compressor pressure monitoring, medical, agricultural machinery and testing equipment, O-ring boss seal is an essential and necessary part in pressure sensor/transducer.
This system is used most frequently in hydraulics, although it has been applied to other systems including compressed air systems and vacuum pumps, such as many Robinair pumps, in which the intake tee has an o-ring boss seal on the bottom. The ORB system can be confused with other connection systems, such as NPT. While threads of different connectors sometimes fit (although often very inexactly), o-ring boss seal system connectors should never be used with any other type of connectors and vice versa, as leaks are likely. Under the high fluid pressures commonly seen in hydraulic systems, a leak or failure of the connection is quite dangerous and could lead to loss of life.
When ORB adapters are not readily available, one can be fashioned using a 37 degree AN (Army/Navy) flare fitting because the threads are compatible in diameter, pitch and spacing. To do this, a suitable o-ring, washer and nut are obtained separately. The flared end of the male AN flare is machined off (if necessary). Optionally, a chamfer tool (or, if one cannot be obtained, a drill bit) can then be used to knock the inside shoulder off and make a reverse or inward angle that will smooth the flow of the fluid into the fitting bore. The last step is often unnecessary because most applications don't require a smooth flow of fluid unless operating at an extremely high flow rate.
This system has the advantage of being able to be tightened mechanically before being sealed. Most threaded systems, such as NPT, have a seal provided by a taper in the thread, so it is difficult to orient both ends of the hose, pipe or tube so that it is not twisted. In the o-ring boss system, this problem is eliminated because the threads do not seal the connection and therefore can be rotated at least a full revolution before they are sealed while maintaining a proper mechanical connection. The orientation problem could also be solved with a suitable union.